Diferència entre revisions de la pàgina «Testing VirKO board»
De Wiki d'en Jordi Binefa
m (→Programming firmware) |
m (→Preparing uploading) |
||
| Línia 8: | Línia 8: | ||
== Preparing uploading == | == Preparing uploading == | ||
| − | + | Follow these steps on VirKO board: | |
| − | + | * 1st: Connect 5V microusb power supply | |
| − | + | * 2nd: Hold reset (red) button | |
| − | + | * 3rd: While holding reset button, hold IO0 button (close to J1 black connector). At this step boths buttons are being pressed. | |
| − | 5th: Release IO0 button | + | * 4th: Release reset (red) button |
| + | |||
| + | * 5th: Release IO0 button | ||
After these steps, board is ready to be programmed. | After these steps, board is ready to be programmed. | ||
Revisió del 22:24, 8 set 2021
Contingut
Programming firmware
Connecting programmer
Red board: FT232RL FTDI USB to TTL Serial Adapter Module used as a programmer
It is very important to check jumper socket is at 3.3 volts position (by default it is at 5 volts)
Preparing uploading
Follow these steps on VirKO board:
- 1st: Connect 5V microusb power supply
- 2nd: Hold reset (red) button
- 3rd: While holding reset button, hold IO0 button (close to J1 black connector). At this step boths buttons are being pressed.
- 4th: Release reset (red) button
- 5th: Release IO0 button
After these steps, board is ready to be programmed.
Programming from terminal
